Pairing device manually
To pair the device manually:
NOTE: Remember to insert the battery to turn on the device.
-
Remove the rockers using a screwdriver to see the LED.
- On the Home page, tap +.
-
Tap
, select ELKO SmartHUB on the slide-up menu and tap Done.
-
Select any one of the options to add device (A):
- Add Device with Install Code
- Add Device without Install Code
TIP: It is recommended to add the device with install code. -
To pair the device with an install code, tap Add Device with Install Code to display the slide-up
menu. Select any one of the options (B):
- Scan Install Code: you can scan the device for the install code.
- Enter Install Code Manually: you can manually enter the install code from the device.
TIP: you can find the install code on the rear side of the device.After scanning or entering the install code, proceed to Step 7.
- To pair the device without install code, tap Add Device without Install Code.
-
Short press the top right push button 3 times.
The LED blinks amber. -
In the app, select Confirm LED is blinking amber (C) and tap Start Configuration.
-
After a few seconds, a solid green LED indicates that the
device has been successfully paired to the ELKO SmartHUB.
- Tap Done when the pairing is successful.